As we mentioned, ball valves operate by rotating a ball 90° while gate valves are controlled by moving a gate up or down. Because of their design, ball valves can perform an almost immediate shutoff, whereas gate valves are not able to act as quickly. This makes ball valves a better choice for applications where fast cycle speed is desired.
The 90° operation of ball valves makes them faster to cycle, both manually and with an actuator. This is a benefit in most instances but can potentially cause water hammer in high-pressure applications. If the pressure is high enough, the pipe could weaken or even break, which is why users of manual ball valves should turn the levers slowly to avoid water hammer.
Gate valves are commonly found in older home plumbing systems.
On/off control for specialized industries including:Ball valves are also found in newer home plumbing systems.
In the gate valve vs. ball valve debate, cost is a major differentiating factor. Up front, gate valves are less expensive than ball valves, but they can be more susceptible to corrosion which means they will need repairs and replacement more frequently. Ball valves have a higher initial cost, but they are the better choice for longevity since they are more durable and highly effective at forming tight seals.
As we just discussed, gate valves are, in general, less durable than ball valves. In moderate or high cycle applications, gate valves will require routine maintenance or replacement. Most ball valves are designed to be maintenance-free and should be replaced rather than repaired. Three-piece ball valves, however, are designed so that the valve seats and seals can be easily replaced without removing the valve from service. This is why 3-piece ball valves are often used in high cycle or high pressure applications where valve seal failure is likely to occur more quickly. However, 3-piece ball valves typically come with a higher up-front cost than the more popular 1-piece or 2-piece body constructions.